next up previous
Next: Conclusions Up: Characterisation of low pressure Previous: Post-irradiation Characteristics

Comparison to LEC diodes

The reverse current-voltage characteristics of a VPE diode and an LEC diode before and after the radiation fluence are shown in figure 10. Before irradiation the current density is less for the VPE diode than for the LEC diode. After irradiation, however, the reverse current of the VPE diode increased dramatically by over an order of magnitude, but, for the LEC diode the increase was only by a factor of two at a reverse bias of 100 V.

Figure 10: Comparison of the reverse current-voltage characteristics of a VPE and an LEC diode before and after irradiation. The key is: solid line - VPE; dashed line - LEC
[Before radiation] \resizebox{.45\textwidth}{!}{\includegraphics{{epi-7-G170-2-iv3.eps}}} [After radiation] \resizebox{.45\textwidth}{!}{\includegraphics{{epi-lec-20C-post-iv-mm2.eps}}}  

The charge collection of the VPE diode was higher than the LEC diode both before and after irradiation. It should be noted, however, that the VPE diode had a depletion width of only $\sim$30$\mu$m and therefore the effect of a short absorption length will be less significant.


next up previous
Next: Conclusions Up: Characterisation of low pressure Previous: Post-irradiation Characteristics
www person 2000-11-22